Rank: Uber Member
Joined: 4/2/2009(UTC)
Posts: 258
|
The spring that is exposed on the right side below the hammer is "floppy" and does not seem very secure. Once it is in the frame it appears fine but it makes me nervous every time I clean around it. Does anybody else see this or is it just me? |
| "I don't like repeat offenders, I like dead offenders." Ted Nugent
|
|
|
|
|
|
Rank: Newbie
Joined: 4/23/2009(UTC)
Posts: 1
|
It's not just you, I have noticed the same thing in mine, not sure if it is a problem or not yet. I guess time will tell
|
|
|
|
|
|
Rank: Uber Member
Joined: 4/2/2009(UTC)
Posts: 258
|
Right on. I have to send it off anyway (slide closes when I insert a full mag) but I will mention it in my note and see if it's any different when I get it back. I will let you know. |
| "I don't like repeat offenders, I like dead offenders." Ted Nugent
|
|
|
|
|
|
Rank: Newbie
Joined: 2/1/2010(UTC)
Posts: 1
|
The spring is loose to allow removal of the bar and swap triggers with the short pull trigger. It is not a problem when in the grip module as the grip module limits the lateral movement or the spring. From what I can tell it is the reset spring that you are speaking of, the trigger spring is in the hammer.
|
|
|
|
|
|
Rank: Uber Member
Joined: 4/2/2009(UTC)
Posts: 258
|
You are correct sir!!
I never re-posted, my bad. |
| "I don't like repeat offenders, I like dead offenders." Ted Nugent
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
